Ventilation
Control of the heating operation is carried out using sensors: built-in — the temperature sensor of the air environment in the room and/or by the floor temperature sensor placed in the underfloor heating system. This or that type of control is selected by the settings on the touch panel of the thermostat.
The possibility of programming the operating modes of the heating equipment for all days of the week provides savings on heating costs of up to 30 percent or more. Heating floor thermostat Mycond Block provides settings for water circuits against freezing and protection of underfloor heating circuits against overheating.
Purpose: control of heating equipment with electric heating up to 3.5 kW with a current load of up to 16 A or with systems of water circuits of a heated floor (3A). Іn addition to boiler equipment, Block thermostats can work with infrared heating systems, electric radiators or convectors.
Уou can choose temperature control by two sensors, as well as by floor and air temperatures.
The set parameters of the air temperature are maintained with an accuracy of 1 °C, all settings are carried out using illuminated touch buttons located on the bottom panel.
By programming the weekly mode of operation, separately for working days and separately for weekend days, as well as setting the minimum air temperature for the economical mode for the time when no one is in the rooms, provide savings on heating costs in the amount of more than 30%.
You can control the operation of the thermostat through the Mycond SmartApp mobile application.
In addition, by setting the minimum temperature that can be maintained, you can not worry about the system freezing. And by setting the maximum possible floor temperature, you can protect the floor covering from overheating and damage. by default, protection against freezing assumes a temperature in the room not lower than 5 °C, and protection against overheating for the floor — at a temperature of 45 °C.
The display of the Block thermostat shows:
At the bottom of the panel there are touch buttons for setting modes and menu transitions. These buttons are backlit.
With the buttons for automatic mode, you can choose time ranges and the desired air temperature separately for weekdays and weekends.
Adjustments are made according to the sequence outlined in the Installation and Adjustment Instructions.
Additional modifications :
Heating floor thermostat is intended for wall installation in a mounting box and in-wall installation of an external sensor and network wires. Аn external sensor for monitoring the temperature of the floor is placed in the structure of the heating floor, equidistant between the adjacent turns of the water circuit or cable heating system. The place of installation is chosen away from door and window openings, from heating radiators or areas warmed by the sun.
Heating floor thermostat Mycond Block will help not only provide heat in the house in advance before your arrival, but also significantly save your resources during the heating season.
Installation tips
Install the thermostat at about 1.2-1.5 m above the floor in a well-ventilated
area with moderate ambient temperature.
Do not install in locations where the thermostat can be affected by: